Home
Products
Olt & Pon Modules
Pon Modules
Epon Olt
Epon Olt Modules
Gpon Olt Modules
Gpon Olt
XGSPON OLT
ONU
Xpon Onu
Epon Onu
Gpon Onu
Router
SFP/SFP+ Modules
10g Sfp Module
Copper Sfp Module
Sfp Module
Media Converter
Switch
Ethernet Switches
POE Switches
Reverse PoE Switch
Managed Switch
Product Video
Xpon Onu Video
Epon Onu Video
Sfp Module Video
10G Sfp Module Video
Copper Sfp Module Video
Media Converter Video
Olt Video
Ethernet Switch Video
POE Switch Video
Managed Switch Video
ONU Video
Router Video
Switches Video
OEM/ODM
360° New model
Blog
Company News
Industry News
New product release
Knowledge
Troubleshooting/solution
Support
Video Guide
Technical Support
Download DATASHEET
About Us
About Company
FAQs
Contact Us
Message Board
VR Factory
Featured
Home
News
Blog
Nonlinear modulation (Angle modulation)
When we transmit a signal, whether it is an optical signal or an electrical signal or a wireless signal, if it is transmitted directly, the signal is susceptible to noise interference, and it is difficult to obtain the correct information at the receiving end. In order to improve the anti-interfe...
Read More
Binary Digital modulation
The basic ways of binary digital modulation are: binary amplitude keying (2ASK)- the amplitude change of the carrier signal; Binary frequency shift keying (2FSK)- the frequency change of the carrier signal; Binary phase shift keying (2PSK)- Phase change of the carrier signal. Because of the phase...
Read More
WIFI Technology Overview
WiFi is an international Wireless local area network (WLAN) standard, full name Wireless Fidelity, also known as IEEE802.11b standard. WiFi was originally based on IEEE802.11 protocol, published in 1997, defined WLAN MAC layer and physical layer standards. Following the 802.11 protocol, many vers...
Read More
Optical eye image debugging
Optical eye image debugging Target: Extinction ratio Research and development stage: between 10-15 (large is better than small), according to the actual situation can be appropriate to improve the extinction ratio, but not too low. It’s related to sensitivity. Quiver Research and develo...
Read More
The construction of the test environment
Core and principle of test environment construction: 1. Check whether the optical power exists Generally use optical power to test whether there is optical power; And the optical power of some ophthalmograms is -2dbm, -3dbm, etc. 2. Whether the clock is accurate The clock is the reference infor...
Read More
Light eye map basic explanation II
A deep interpretation of jitter If the data rate of the system is increased, the jitter amplitude measured in a few seconds will remain roughly the same, but when measured in a fraction of the time of the bit period, it will increase proportionately with the data rate, resulting in bit errors. Th...
Read More
<<
< Previous
1
2
3
4
5
6
Next >
>>
Page 3 / 78
WhatsApp Online Chat !